Turnkey LineTurnkey
Turnkey Line
Three core machines — buckle fastening, steel-edge forming and hydraulic pressing — from one accountable partner.
3 core machines3-stage system3-year warranty
Products
Steel-edged plywood box production equipment
Three core machines form the standardized production system: buckle fastening, steel-edge forming and hydraulic pressing. Each machine is quoted with its own technical specification sheet, or take the three-machine line that has already been matched to itself.
DA-8000Fastening
Nailless Buckle Machine
Fastens plywood box panels with steel buckles — no nails, no split panel edges, no fumigation dependency.
30–60/min9,000 mm assembly6 kW
GA-8000Forming
Steel Edge Plywood Box Machine
Punches and cuts coiled steel strip into uniform steel edges for plywood box panels.
Six-year die warrantyOMRON PLCSKD51 punch
GA 2.5 mPressing
Steel-Edge Hydraulic Press
Joins preformed steel edges with prepared plywood under stable hydraulic force for flat, rigid, dimensionally consistent panels.
30 t press force2.5 m working widthMagnetic die
How the three stages fit together
A plywood export box is a set of flat panels joined at their edges, and every load path in the box runs through those edges. The standardized production system therefore works the panel in three stages: buckle fastening presses steel buckles into the panel joints, steel-edge forming cold-rolls the edge profile from coiled strip, and hydraulic pressing sets that profile onto the panel.
Buy the stage you are missing, or take the three-machine line so the dies, the press working width and the floor layout are matched to each other before the machines ship. Prices and lead times are confirmed in writing against your box sizes, panel thickness and destination.
Production sequence
| Buckle fastening | DA-8000High-Spec Nailless Plywood Box Buckle Machine |
|---|---|
| Edge forming | GA-8000Steel Edge Plywood Box Machine |
| Hydraulic pressing | GA 2.5 mSteel-Edge Hydraulic Press |
Not sure which stage you need?
Send the box sizes, panel thickness and the equipment you already own. We will tell you which of the three stages is missing.
Request a quoteEquipment questions
Both. The line is supplied as three matched machines — DA-8000 buckle machine, GA-8000 steel-edge forming machine and Steel-Edge Hydraulic Press — and each machine also carries its own technical specification sheet if you only need one stage.
Under normal operating conditions, electrical control components are covered for 3 years.
The DA-8000 nailless plywood box buckle machine is specified for plywood from 5 mm to 12 mm. Tell us the panel thickness and box sizes you build so we can confirm the configuration.
The DA-8000 fastens at 30 to 60 fasteners per minute. Achievable line output depends on box size, panel handling and how many operators you run — send us your box dimensions and target output and we will set out what the configuration can achieve.
Recommended floor space is 3 × 3 m for the DA-8000, 5 × 2 m for the GA-8000 and 3 × 3 m for the quoted 2.5 m press configuration. Machine dimensions for every unit are listed in its specification table.
Rated power is 6 kW for the DA-8000 and the GA-8000. The GA 2.5 m press build is quoted at 3 kW; the brochure states the press series at 12–15 kW. Voltage and phase are confirmed against your site before order.
Send us the box you need to build
Box sizes, panel thickness and the production stages you need are enough for us to come back with a configuration and a written quotation.